New game from Youthcat Studio The Dyson Sphere Program just went into Early Access, but has already skyrocketed to the top. If you are one of the many players who have purchased this sci-fi simulator, you may feel a little overwhelmed by the sheer scale of the Dyson Sphere Program, where the main goal is to build a star empire. In our guide, we will take a closer look at one of the best ways to automate the extraction of resources in the game - to build the Main Bus, aka the pipeline.
Basically, building and configuring a master bus is about optimizing your production setup by creating a central hub where the most commonly used resources can be collected. It can take a while to create a well-structured layout, but it will be helpful later on. The main conveyor system is optional for the Dyson Sphere Program, but using even some of these tips can help organize your production system.
Much of setting up your main conveyor will involve managing and building an optimized belt system (s) that will transport resources to and from your equipment. In order to do everything right, you must consider several factors:
- distance between tapes;
- location of the tape;
- merging tapes;
- belt height;
- types of splitters.
Distance between belts
The game world is divided into symmetrical squares. This helps to build and plan further development. The smaller squares, in turn, are separated by more prominent lines. This whole system resembles longitude and latitude. You will need ribbons on every 4th noticeable line. Of course, it is possible to build closer, but then there is not enough space for equipment and splitters. Therefore, a distance of three squares between conveyor belts is optimal.
Ribbon location
Make sure to run the main belt along the equator and not north to south. The equator is easy to identify - it is a large green line. Thus, you will have the opportunity to make the main tire as long as possible, and it will also be much easier to control due to the coordinate system that is also present in the game. When you're just starting out, running out of space won't be an issue, but by the middle of the game you will definitely feel the importance of planning your pipeline properly.
Merging tapes
The Dyson Sphere Program allows you to build vertically. This means that you can build ribbons on top of other ribbons and connect them at different levels. We recommend using this technology more often. While your most important resources remain on the bottom belt for easy access, you can put something else on the top. In order to optimize the vertical belts in the best way, it is necessary that they pass through the 1st and 3rd levels, as this allows the belts to merge at the bottom without taking up too much vertical space.
Belt height
Only odd numbered heights should be used for tapes. This is because 4-way splitters will only connect at these heights. You can use even heights for resource I / O using other types of splitters.
Splitter types
Now let's talk about the types of splitters that you can use to build your main pipeline. We recommend not to overlook the different types of splitters. Use the Tab key to change the type when placing. You will find that one of these in particular can be very useful for I / O resources from a single line.
You should start the first tape right at the equator. Each additional one is added above it, and all factories must be below the equator.
Comments
Post a Comment