Dying Light 2 Stay Human is a new open-world action game where you have to fight the infected and other mutants. In the course of the passage, you may have difficulty repairing melee weapons. You can solve this problem with the Korek amulet. You can find it in the secret developer room. In this guide, we will tell you where it is.
The weapon repair system in Dying Light 2 Stay Human is unusual. You can restore the durability of an ax, sword or machete with the help of improvements. But the number of upgrades is strictly limited, so you won’t be able to walk with the same weapon for a long time. At least, if you do not use our cunning.
How to endlessly repair weapons in Dying Light 2 Stay Human. Why do you need the amulet "Korek"
The amulet is built into any melee weapon and immediately restores 500 points of durability (while the usual improvement is only 50 points). But the most important thing is that this item can be removed and reinserted an unlimited number of times. Thus, you will be able to use your favorite cold weapon even until the very end of the game, because it will never break.
Where is the Korek amulet located? How to find the secret developer room of Dying Light 2 Stay Human
The blueprint for the amulet is in the Techland dev room. To get into it, you must first complete the " Broadcast " story mission. The action algorithm is as follows:
- Get to the top of the VCN tower.
- Use the paraglider to fly to the roof of the skyscraper with antennas (here lies the army cargo THB-UT0).
- Find the electrical panel and take the cable.
- Turn around, jump down and climb into the room, which is located two floors below.
- Connect the cable to the power source.
- On this floor, you will find another shield. Take the second cable and jump down to the balcony.
- Find the same device in the room and connect the cable to the power source.
- Take the next cord. It is located in the opposite corner of the building. Interact with the device.
- Turn left and jump down. Then look to the right and go down even lower.
- Enter the room and connect the last cable.
- Interact with the control panel using the VGM key, then open the door.
Comments
Post a Comment